IBM RS/6000 7043 43P Series, User Manual

Page: 105 / 322

Handling Static Sensitive Devices
Attention: Static electricity can damage this device and your system unit. To avoid
damage, keep this device in its static protective bag until you are ready to install it.
To reduce the possibility of electrostatic discharge, follow the precautions listed
below.
Electrostatic Discharge Protection
To prevent electrostatic discharge:
Ÿ
Limit your movement. Movement can cause static electricity to build up around
you.
Ÿ
Handle the device carefully, holding it by its edges or its frame.
Ÿ
Do not touch solder joints, pins, or exposed printed circuitry.
Ÿ
Do not leave the device where others can handle and possibly damage the
device.
Ÿ
While the device is still in its anti-static package, touch it to an unpainted metal
part of the system unit for at least two seconds. (This drains static electricity
from the package and from your body.)
Ÿ
Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it on its
static-protective package. (If your device is an adapter, place it component side
up.) Do not place the device on your system unit cover or on a metal table.
Ÿ
Take additional care when handling devices during cold weather as heating
reduces indoor humidity and increases static electricity.
Tools Required
To install or remove options from your system unit, you need a flat-blade screwdriver.
Any additional tools needed depend upon the specific option and are noted in the
instructions that come with the option.
Chapter 4. Installing and Removing Options
4-3