IBM RS/6000 7043 43P Series, User Manual, Page: 271 / 322

Use this service aid to display and change the following settings for the Ring Indicate
Power On Policy.
Note: Because of system capability, some of the following settings may not be
displayed by this service aid.
Ÿ
Power On Via Ring Indicate (on/off)
Ÿ
Number of Rings Before Power On
This service aid may be accessed directly from the AIX command line, by entering:
/usr/lpp/diagnostics/bin/uspchrp -r
Configure Ring Indicate Power On
Note: Runs on RSPC systems units only.
This service aid allows the user to display and change the NVRAM settings for the
Ring Indicate Power On capability of the service processor.
The settings allows the user to:
Ÿ
Enable/Disable power on from Ring Indicate
Ÿ
Read/Set the number of rings before power on
Configure Service Processor
Note: Runs on RSPC systems units only.
This service aid allows you to display and change the NVRAM settings for the
service processor.
This service aid supports the following functions:
Ÿ
Surveillance Setup
Ÿ
Modem Configuration
Ÿ
Call In/Call Out Setup
Ÿ
Site Specific Call In/Call Out Setup
Ÿ
Reboot/Restart Policy Setup
Surveillance Setup
This selection allows you to display and change the NVRAM settings for the
surveillance capability of the service processor.
The settings allow you to:
Chapter 9. Introduction to Tasks and Service Aids
9-11