IBM pSeries 650, Installation Manual

Page: 76 / 190

9. Visually check to ensure that the cassette is parallel with the cassettes to the left or right. If the
cassette is not parallel with the neighboring cassettes, the cassette dovetail rails might not be
correctly engaged. If the cassette is not correctly aligned, you might need to pull it out so you can see
the ends of the dovetail rails. If so, reinsert the cassette, ensuring that the dovetail rails engage on
both sides of the cassette.
Note: If there are no other cassettes installed, it is not necessary to check the alignment of the
dovetail rails.
10. When the cassette is fully inserted, ensure that the lock bar is in the unlocked position (pulled out).
11. Depress the handle release latch. Lift the handle up until the handle-release lever clicks when it locks
into position.
Note: To aid you in seating the PCI adapter connector, it may be necessary to press down on the
adapter tailstock tab. The PCI adapter is completely installed into the PCI adapter slot when
the handle is in the fully raised position and the tailstock is seated into the slots located on the
system board.
Attention: Do not force the handle into the raised position.
Non-Hot-Pluggable PCI Adapter Removal and Replacement
Because this procedure is done with the power turned off, ensure that the system is available to be shut
down.
Removing a Non-Hot-Pluggable PCI Adapter
To remove a non-hot-pluggable adapter, do the following:
1. Turn off power and remove the power from the system as described in “Stopping the System” on page
45.
2. Determine the slot from which you are removing the adapter.
3. Refer to “Removing a PCI Adapter Cassette” on page 55. When you have completed the PCI adapter
cassette removal procedure, return here.
4. If you are installing another adapter in this slot, follow the instructions given in “Installing or Replacing
a Non-Hot-Pluggable PCI Adapter.”
If you are not installing another adapter in this slot, install a blank filler in the cassette and then install
the cassette into the empty slot. For information about installing a blank filler in a cassette, see “Short
Adapter or Blank Filler Installation” on page 84.
5. Connect power to the system and turn on the power.
6. Return the system to normal operations.
Installing or Replacing a Non-Hot-Pluggable PCI Adapter
Install the adapter using the following procedure:
Note: Because the adapter you are installing is not hot-pluggable, shut down the system and remove
power before performing this procedure.
1. If you have just removed an adapter and you are replacing it in the system, use the procedures in “PCI
Adapter or Blank Filler Removal from a Cassette Assembly” on page 67 to install the replacement
adapter into the PCI adapter cassette, return here.
2. Go to “Replacing a PCI Adapter Cassette” on page 58 to replace the appropriate cassette in the PCI
slot, then return here.
3. Set the color slide to blue.
4. Connect power to the system and turn on the power as described in “HMC Power-On Method” on
page 29.
5. Ensure that the adapter is configured when the system completes the boot process.
60
Eserver
pSeries 650 Installation Guide