IBM pSeries 650, Installation Manual

Page: 27 / 190

Step 3. Attach the Mounting Hardware to the Rack Enclosure
To attach the mounting hardware, you will need the following items:
v
Rack-Mounting Template
v
2 Rack Rails
v
Cable Management Arm
v
Rack-Mounting Kit Envelope
v Screwdriver or Nutdriver
1. Install the slide-rails and the cable management arm on the mounting rails of the rack enclosure.
Note: If you do not have the rail template, go to “Rail Positioning Without a Template” on page 14.You
must align the rack slide rails correctly. Otherwise, the installation cannot be completed
successfully.
a. Position the template on the front rack-mounting rails, aligning the holes.
b. Install the nut clips (item 8 in the following illustration), using the locations shown on the template.
c. Install the EIA plates (items 4 and 7 in the following illustration), and attach them to the
rack-mounting rail with an M5 rack screw in the lower of the two nut clips.
8
7
5
6
4
3
2
1
1 Rack 5 M5 Screw for EIA Plates
2 Left Rail (from front) 6 M5 Screw for Rails
3 Right Rail (from front) 7 Left EIA Plate (from front)
4 Right EIA Plate (from front) 8 M5 Nut Clip
Chapter 2. Installing the pSeries 650
11