IBM pSeries 650, Installation Manual

Page: 163 / 190

Testing Call-Out
During the setup, you entered your phone numbers for the pager and customer voice (refer to the
Eserver
pSeries 650 Model 6M2 Service Guide for more information. These numbers are used for this
test.
1. Your remote terminal is disconnected as a result of the Call-In test.
2. Call your server again.
3. At the service processor Main Menu, select Call-In/Call-Out Setup menu, then select Call-Out test.
This action causes a simulated error condition for the purposes of this test.
4. After a few moments, a message displays, regarding an illegal entry. Press Enter to clear the message
and return to the main menu.
5. When your telephone rings, answer the call. You should hear the sound of a telephone being dialed.
This is your computer trying to page you.
If this test is successful, call-out is working correctly.
Serial Port Configuration
To configure the serial port on an AIX system, run the following from an AIX console:
1. Log in as
root
user.
2. To determine if you have any serial ports already configured, type:
lsdev -Cc tty
If no serial ports are configured, none are listed. If you want to configure serial ports that are not
listed, continue with the remaining steps.
3. Identify the serial port(s) with the modem(s).
4. Type smit tty
5. Select add tty
6. Select RS232
7. Select Baud rate 9600 or higher.
8. Select login enable and set the flow control to RTS.
9. Commit the selections and set up any other needed serial ports.
10. Exit SMIT.
Appendix F. Service Processor Setup and Test
147