IBM pSeries 650, Installation Manual

Page: 31 / 190

Step 4. Install the System in the Rack Enclosure
CAUTION:
The stabilizer must be firmly attached to the bottom front of the rack to prevent the rack from
turning over when the drawers are pulled out of the rack. Do not pull out or install any drawer or
feature if the stabilizer is not attached to the rack.
C16
Attention: When installing this unit in a rack, ensure that a hazardous condition is not created due to
uneven mechanical loading. If the rack has a stabilizer, the stabilizer must be firmly attached before
installing or removing this unit.
Attention: This procedure requires use of a lift tool.
1. Mount the server on the slide rails as follows.
a. Extend the slide rails fully from the rack until the slide rails lock.
b. Using a lift tool, lift the server and position it so that the rails align with the rack-rail holes.
c. Slide the server backward or forward as necessary until the rail holes align with the holes in the
side of the server.
d. Attach the rails to both sides of the server with M4 by 5-mm screws (Item 1 in the following figure).
1
1 M4 by 5-mm Screws
Chapter 2. Installing the pSeries 650
15