IBM pSeries 650, Installation Manual

Page: 47 / 190

v
Select Language
v OK Prompt
Power On Open Firmware OK Prompt
This profile is used only by service representatives to obtain additional debug information. When
this selection is enabled, the system boots to the open firmware prompt.
To learn more about these power-on options, see the IBM Hardware Management Console for pSeries
Installation and Operations Guide .
System Profiles: The System Profile option powers on the system according to a predefined set of
profiles.
Note: The profiles are activated in the order in which they are shown in the system profile.
Configuring the Network Using the HMC: To to complete the installation, the following configuration
tasks must be performed:
v
Configuring Inventory Scout Services
v
Configuring Service Agent
v
Collecting Vital Product Data (VPD)
v Transmitting VPD
For more information about performing these tasks, refer to the IBM Hardware Management Console for
pSeries Installation and Operations Guide .
Operator Panel Power-On Method
Perform the following steps to power on the processor subsystem and attached I/O subsystems using the
power button on the operator panel.
1. Open the rack door. Look for OK in the operator panel display, which indicates that the system is in
standby.
2. Press the power button on the operator panel.
The power LED on the operator panel starts blinking at a fast rate. 9xxx checkpoints appear in the
operator panel display.
When the power-on sequence is complete, the following events have occurred:
v
The power LED on the system operator panel stops blinking and stays on.
v The power LEDs on the I/O subsystem come on and stay on.
Chapter 3. Verifying the Hardware Operation
31