IBM PCIe3 x8 SAS RAID internal adapter 6 Gb, Manual

Page: 27 / 130

2. Identify the part and the system that you will be working on. For instructions, see “Identifying a
part” on page 22.
3.
Stop the system or logical partition. For instructions, see “Stopping a system or logical partition” on
page 33.
4. For a rack-mounted system, place the system into the service position. For instructions, see “Placing
the rack-mounted system into the service position” on page 56.
5. Attach the electrostatic discharge (ESD) wrist strap. The ESD wrist strap must be connected to an
unpainted metal surface until the service procedure is completed, and if applicable, until the service
access cover is replaced.
Attention:
v Attach an electrostatic discharge (ESD) wrist strap to the front ESD jack, to the rear ESD jack, or to
an unpainted metal surface of your hardware to prevent the electrostatic discharge from damaging
your hardware.
v
When you use an ESD wrist strap, follow all electrical safety procedures. An ESD wrist strap is
used for static control. It does not increase or decrease your risk of receiving electric shock when
using or working on electrical equipment.
v If you do not have an ESD wrist strap, just prior to removing the product from ESD packaging
and installing or replacing hardware, touch an unpainted metal surface of the system for a
minimum of 5 seconds. If at any point in this service process you move away from the system, it
is important to once again discharge yourself by touching an unpainted metal surface for at least 5
seconds before you continue with the service process.
6. Remove the service access cover. For instructions, see “Removing the service access cover from a
5148-21L, 5148-22L, 8247-21L, 8247-22L, 8247-42L, 8284-21A, 8284-22A, 8286-41A, or 8286-42A
system” on page 48.
7.
Look for the amber LED (B) of the PCIe3 x8 SAS RAID internal adapter 6 Gb that you are removing.
See Figure 9 on page 10.
PCIe3 x8 SAS RAID internal adapter 6 Gb
9