IBM Netfinity 6000R, User Reference Manual

Page: 91 / 218

Chapter 6. Installing options
77
Removing the server top cover and bezel
Review the information in “Before you begin” on page 71.
The following illustration shows how to remove the top cover and bezel from the
server.
Note: The illustrations in this document might differ slightly from your hardware.
To remove the server top cover:
1. Lift the plastic cover-release latch near the edge of the top cover.
2. Slide the top cover slightly toward the rear of the server; the cover will stop after
about 25 mm (1 inch). Lift the cover off the server and set the cover aside.
Attention: For proper cooling and airflow, replace the top cover before turning
on the server. Operating the server for extended periods of time (over 30 minutes)
with the top cover removed might damage server components.
To remove the bezel:
1. Release the two tabs at the top edge of the bezel and pull the top of the bezel
slightly away from the server.
2. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store the
bezel in a safe place.
Top cover
Release latch
Release latch
Cover release latch
Bezel