IBM Netfinity 6000R, User Reference Manual

Page: 120 / 218

106
IBM® Netfinity® 6000R User’s Reference
Auxiliary-device (pointing device) port
The system board has one auxiliary-device port that supports a mouse or other
pointing device.
The following table shows the pin-number assignments for the auxiliary-device
connector on the rear of your server.
Ultra160 SCSI ports
Your server has an integrated dual-channel Ultra160 small computer system interface
(SCSI) controller. This controller supports two independent Ultra 160/m SCSI
channels: one internal and one external. Each of these channels supports up to 15
SCSI devices. In addition, this controller uses:
• Double-transition clocking to achieve high transfer rates
• Domain name validation to negotiate compatible data transfer speeds with each
device
• Cyclic-redundancy checking (CRC), instead of the usual parity checking, to
significantly improve data reliability
• An active terminator on the system board for SCSI bus termination
The server comes with two SCSI cables; each cable is connected to one of the SCSI
channels. One SCSI cable connects the internal SCSI channel connector to the
standard hot-swap-drive backplane. The other SCSI cable is connected to the external
SCSI channel connector; however, this connector is cabled for internal use. If you
want to use the external LVD SCSI channel connector to connect external SCSI devices
to the server, remove the knockout on the rear of the server and install the LVD SCSI
cable that comes with the server.
Note: If you install a PCI RAID adapter to configure and manage the internal hot-
swap drives, you must move the SCSI cable from the system-board SCSI
connector to an internal channel connector on the RAID adapter. See
“Cabling example for the ServeRAID adapter” on page 80 for additional
information.
Pin Signal
1 Data
2 Not connected
3 Ground
4 +5 V dc
5 Clock
6 Not connected
Table 11. Auxiliary-device connector pin-number
assignments
6
4
2
1
3
5