IBM H Series, Installation And Service Manual

Page: 158 / 438

Table 3-7 (Page 2 of 3). Model H70 Service Processor Checkpoints
Checkpoint Description Action/
Possible Failing FRU
E044 Preparing to set serial port line
speed 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E045 Preparing to initialize serial port 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E060 Preparing to auto power-on (AC
restored) 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E061 Preparing to auto power-on (Timer) 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E070 Configuring modem 1. Modem.
2. I/O board. (See notes on 3-1.)
3. CPU Card.
E072 Preparing to call home 1. Modem.
2. I/O board. (See notes on 3-1.)
3. CPU Card.
E075 Entering SP menus 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E076 Leaving SP menus; attempting to
disconnect modems 1. I/O board. (See notes on 3-1.)
2. CPU Card.
D E080 D Entering service processor emer-
D gency firmware flash recovery
D process.
D 1. Insert a new DOS-formatted
D diskette containing the service
D processor firmware update into
D the diskette drive. The firmware
D image must be named
D spflash.img.
D Note: Insert the diskette only
D after checkpoint E080
D displays.
D 2. Cycle ac power and retry the
D flash recovery.
D 3. Cycle the ac power again with
D another new diskette and retry
D the flash recovery.
D 4. Replace the I/O board.
E0A0 Beginning Bring-Up Phase 1. I/O board. (See notes on 3-1.)
2. CPU Card.
E0B0 Starting CPU BIST 1. CPU Card.
2. I/O board. (See notes on 3-1.)
E0C0 Starting X5 BIST 1. CPU Card.
2. I/O board. (See notes on 3-1.)
E0D0 Creating JTAG scanlog (failure diag-
nostic information) N/A--wait for completion
E0E0 Pulling CPU out of reset 1. CPU Card.
2. I/O board. (See notes on 3-1.)
3-50
RS/6000 Enterprise Server Model H Series Installation and Service Guide