IBM eServer BladeCenter HS20 Type 8832, Problem Determination And Service Manual

Page: 60 / 112

v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v
See Chapter 3, “Parts listing, Type 7981 and 1884,” on page 53 to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by “(Trained service technician only),” that step must be performed only by a
trained service technician.
Error code Description Action
001-250-000 Failed processor board ECC.
1. Reseat the following components:
a. DIMMs
b. (Trained service technician only)
Microprocessor 1
c. (Trained service technician only)
Microprocessor 2
2. Replace the following components one at a time,
in the order shown, restarting the blade server
each time:
a. DIMMs
b. (Trained service technician only)
Microprocessor
c. (Trained service technician only)
Microprocessor 2
d. (Trained service technician only) System
board assembly
001-292-000 Core system: failed/CMOS checksum failed. Load the BIOS default settings by using the
Configuration/Setup Utility program and run the test
again (see the Installation and User’s Guide for your
blade server).
001-xxx-000 Failed core tests. (Trained service technician only) Replace the system
board assembly.
001-xxx-001 Failed core tests. (Trained service technician only) Replace the system
board assembly.
005-xxx-000 Failed video test. (Trained service technician only) Replace the system
board assembly.
030-xxx-000 Failed internal SAS interface test. (Trained service technician only) Replace the system
board assembly.
035-xxx-099 No adapters were found. Reseat the adapter (if installed).
075-xxx-000 Failed power supply test. Replace the power supply (see the Hardware
Maintenance Manual and Troubleshooting Guide or
Problem Determination and Service Guide for your
BladeCenter unit).
44
BladeCenter HS20 Type 7981 and 1884: Problem Determination and Service Guide