IBM eServer 130 xSeries, User Reference Manual

Page: 82 / 156

68
IBM xSeries 130: User’s Reference
Installing the cover
Complete the following steps to install the appliance server cover:
1. Clear any cables that might impede the replacement of the clear shield or the
cover.
2. Install the clear shield, if it was removed.
Attention: Before sliding the cover forward, make sure that all of the tabs on the
cover will engage the ledge at the front of the appliance server properly. If all the
tabs do not engage the ledge properly, it will be extremely difficult to remove the
cover later.
3. Install the cover by placing it into position and sliding it forward. Make sure that
the cover engages the tabs at the front and rear of the appliance server.
4. Install the screws, and secure the cover as shown.
Figure 21. Installing the cover
5. If required for your configuration, install the appliance server in a rack cabinet.
6. Go to “Cabling the appliance server” for information on how to connect cables to
your appliance server.
Cabling the appliance server
This section contains the information you need to cable your appliance server. To
cable the model:
• 8654, see “Cabling the model 8654 appliance server” on page 69.
• 8672, see “Cabling the model 8672 appliance server” on page 73.
Screws