IBM CI5VGM Series, User Manual

Page: 129 / 134

Chapter 8 Ethernet Setup User’s Guide
CI5VGM User’s Manual 125
Running Diagnostics
The CI5VGM comes with a diskette containing the diagnostic software
supporting the Intel 82558B Ethernet controller. Follow the steps below
to use the
Setup Utility .
1. Run the file
SETUP.EXE
typing
a:\setup
in the DOS prompt,
assuming your floppy disk drive is drive A. Upon doing so, the
system starts the
Setup Utility
and shows the following screen.
8255x-based PCI EtherExpress™ adapter Setup V4.16
Main Menu
Automatic setup
View adapter configuration
Test adapter
Install network drivers
View Help files
Exit Setup
Choose AUTOMATIC SETUP to view the adapter
’
s configuration, make sure it
works properly, and install the software needed to connect to your network.
Help = F1 Exit = Esc Select =
↑↓
Action =
↵
2. Selecting
View adapter configuration will show the following.
8255x-based PCI EtherExpress™ adapter Setup V4.16
View adapter configuration
Adapter type:…………………..
Adapter part number:………….
Network address:………………
Interrupt:………………………..
Bus:……………………………..
Slot:……………………………..
Device:………………………….
Network speed:………………..
Physical layer device:…………
Duplex:………………………….
Adapter capabilities:
100BaseTX, full or half duplex.
10BaseT, full or half duplex.
Press Enter to continue
Help = F1 Previous = Esc Continue = Enter PCI Advanced = F5