IBM BladeCenter JS20, Maintenance And Troubleshooting Manual, Page: 151 / 218

Service
request
number
SRN
source Description FRU/action
A1D-37x G A non-critical error has been detected:
Clock or PLL Error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A1D-38x G A non-critical error has been detected:
Hardware Scan or Initialization Error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A1D-40x G A non-critical error has been detected:
Presence/Detect Error (Mis-Plugged).
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A24-000 G Spurious interrupts on shared interrupt
level have exceeded threshold
1. Check the BladeCenter management module
event log. If an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. Replace part numbers reported by the
diagnostic program.
3. If no entry is found, replace the system board.
A24-xxx G Spurious interrupts have exceeded
threshold.
1. heck the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. Replace part numbers reported by the
diagnostic program.
3. If no entry is found, replace the system board.
A1D-50x G Recoverable errors on resource indicate
a trend toward an unrecoverable error.
However, the resource could not be
deconfigured and is still in use. The
system is operating with the potential for
an unrecoverable error.
1. If repair is not immediately available, reboot
and the resource will be deconfigured;
operations can continue in a degraded mode.
2. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
3. If no entry is found, replace the system board.
Failing Function Codes (FFCs)
Failing function codes represent functions within the system unit.
Note: When replacing a FRU, use the following procedure to verify the fix:
Chapter 10. Symptom-to-FRU index
141