IBM BladeCenter JS20, Maintenance And Troubleshooting Manual, Page: 140 / 218

Service
request
number
SRN
source Description FRU/action
A10-200 E The resource was marked failed by the
platform. The system is operating in
degraded mode.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A10-210 D The processor has been deconfigured.
The system is operating in degraded
mode.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A11-00x G A non-critical error has been detected.
Error log analysis indicates an error
detected by the CPU, but the failure
could not be isolated.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A11-01x G A non-critical error has been detected, a
CPU internal error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A11-02x G A non-critical error has been detected, a
CPU internal cache or cache controller
error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A11-03x G A non-critical error has been detected, an
external cache parity or multi-bit ECC
error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, see “Undetermined
problems” on page 156
A11-05x G A non-critical error has been detected, a
system bus time-out error.
1. Check the BladeCenter management module
event log; if an error was recorded by the
system or if a checkpoint code is displayed on
the console, see Chapter 10,
“Symptom-to-FRU index,” on page 93.
2. If no entry is found, replace the system board.
A11-06x G A non-critical error has been detected, a
time-out error waiting for an I/O device.
v Check the BladeCenter management module
event log for an entry around this time. If no
entry is found, replace the system board.
130
BladeCenter JS20 Type 8842: Hardware Maintenance Manual and Troubleshooting Guide