IBM BladeCenter HT 8740, Problem Determination And Service Manual

Page: 95 / 158

Removing a network clock-module filler
To remove a network clock-module filler, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Pull the release handle to the open position. The module moves out of the bay
approximately 0.6 cm (0.25 inch).
3. Slide the filler out of the bay. Within 1 minute, install either another module or a
filler into the module bay.
4. If you are instructed to return the network clock-module filler, follow all
packaging instructions and use any packaging materials for shipping that are
supplied to you.
Chapter 4. Removing and replacing BladeCenter HT components
77