IBM BladeCenter HT 8740, Problem Determination And Service Manual

Page: 91 / 158

Removing a management-module interposer
To remove a management-module interposer or tray filler, complete the following
steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Remove the bezel, if installed, to access the management-module interposer to
be removed (see “Removing a bezel collar” on page 41).
3. If a management module or filler is installed in the management-module bay,
remove it (see “Removing a management module” on page 75).
4. Pull the management-module interposer release handle to the open position.
The interposer moves out of the bay approximately 0.6 cm (0.25 inch).
5. Pull the interposer out of the bay. Within 1 minute, install either another module
or a filler into the module bay.
6. If you are instructed to return the interposer, follow all packaging instructions
and use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing BladeCenter HT components
73