IBM BladeCenter HT 8740, Problem Determination And Service Manual

Page: 82 / 158

Removing an I/O module
To remove an I/O module or module filler, complete the following steps.
Note: These instructions assume that the BladeCenter HT unit is connected to
power.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 31.
2. Remove the bezel as needed to access the I/O module to be removed (see
“Removing a bezel collar” on page 41).
3. Disconnect all cables from the module.
4. Pull the release handle or handles to the open position. The module moves out
of the bay approximately 0.6 cm (0.25 inch).
5. Slide the module out of the bay. Within 1 minute, install either another module
or a filler into the module bay.
6. If you are instructed to return the I/O module, follow all packaging instructions
and use any packaging materials for shipping that are supplied to you.
64
BladeCenter HT Type 8740 and 8750: Problem Determination and Service Guide