Power source requirements
The BladeCenter S system can run on either 110 V ac or 220 V ac. Each of the four
power supplies in the BladeCenter S chassis is capable of handling either type of
power source.
Note:
Although the power modules are autoranging and can support either 110 V
ac or 220 V ac, you cannot mix voltage power sources within the same BladeCenter
S system. All power modules within a BladeCenter S system must be connected to
either a 110 V ac or 220 V ac power sources.
AC power input must be adequate to supply the required voltage and amperage at
an input frequency range from 50-60 hertz (Hz). The BladeCenter S system requires
the following ac input voltage:
Table 3. ac input voltage requirements
Nominal Voltage
Minimum Voltage
Maximum Voltage
110 V ac
100
127
220 V ac
200
240
The ac input current requirements are shown in the following table:
Table 4. ac input current requirements
Nominal Voltage
Nominal Amps
Maximum Continuous Amps
100 V ac
11.2
13.9
200 V ac
8.0
9.0
Power consumption guidelines
The BladeCenter S system is configurable with varying numbers of some
individual components. As you add components to the BladeCenter S system, the
power consumption increases.
Blade servers, fan modules, SAS or SATA drives, and other components all
contribute to the power footprint. A BladeCenter S system can have a minimum of
two or a maximum of four power supply modules that must provide the 12-volt
power for all of the components that you are including in the chassis.
Table 5. Power consumption of BladeCenter S system components
Component
Maximum Watts
Midplane
5W
Media tray
7.5W
Fans (four)
240W
Advanced management module
25W
Power module fans (two power modules)
20W
I/O module
45W
SAS connectivity module
65W
SAS RAID controller module
65W
Battery backup unit
10W
Storage module
120W
Chapter 2. Planning for the physical environment
29
Summary of Contents for 88861TU
