IBM 87302RU, Hardware Maintenance Manual

Page: 54 / 180

Installing the bezel assembly
Complete the following steps if you are installing the bezel assembly at the front of
the BladeCenter T unit:
1. Ensure that the bezel lock is open; then, insert the bottom bezel hooks into the
bezel slots at the bottom of the BladeCenter T unit.
2. Push in the bottom and the top of the bezel assembly until they both click firmly
into place; then, close the bezel locks by sliding the bottom half of the bezel
lock retention latch down until it stops.
Removing and installing the bezel air filter
The air filter is installed behind the front bezel of the BladeCenter T unit.
Important: If the BladeCenter T unit contains any blade servers with standard
(high-profile) release levers, the bezel assembly will not fit on the chassis. The
bezel assembly and air filter can be used only if all blade servers in the chassis
have low-profile release levers.
Note:
v
Read “Installation guidelines” on page 37.
v Read “Important safety information” on page iii.
v
Read “Handling static-sensitive devices” on page 40.
CM
M
1
CM
M
2
ESD
Bezel
Air filter
Retainer
Complete the following steps to replace the front bezel air filter in the BladeCenter
T unit:
44
BladeCenter T Type 8720 and 8730: Hardware Maintenance Manual and Troubleshooting Guide