IBM 87302RU, Hardware Maintenance Manual

Page: 69 / 180

Removing the LAN module
Complete the following steps to remove a LAN module from the rear of the
BladeCenter T unit:
1. Fully loosen each thumbscrew counter clockwise.
2. Grasp the LAN module by both thumbscrews.
3. Carefully pull the LAN module outward from the LAN module bay until you feel it
release from the card edge connector on the backplane.
4. Remove the LAN module from the bay and set it aside.
5. Within 1 minute, install the new LAN module.
Installing the LAN module
Complete the following steps to install a LAN module into the rear of the
BladeCenter T unit:
1. Hold the LAN module by both thumbscrews.
2. Position the LAN module into the rails inside the LAN module bay (see the
illustration of the KVM and LAN modules on page 56).
3. Push the LAN module into the bay until it stops. Make sure that it is snug.
4. Turn each thumbscrew clockwise until it is finger tight. If you use a screwdriver,
make sure that you do not overtighten the thumbscrews.
Chapter 4. Setting up the BladeCenter T hardware
59