IBM 866631Y - Netfinity 7100 - 8666, Hardware Maintenance Manual, Page: 74 / 198

Installing the top cover
Captive screws
Top cover
To install the server top cover:
1. Before installing the cover, check that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2.
Lower the cover with the rear edge of the cover about 25 mm (1 inch) back
from the rear edge of the server.
3. Slide the cover forward.
4.
Tighten the two captive screws on the back edge of the cover.
5. If you disconnected any cables from the back of the server, reconnect the cables;
then, plug the power cords into properly grounded electrical outlets.
Note: If necessary, see “Cabling the server” on page 74 for connector locations.
Reconfiguring the server
When you start the server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. Run the Configuration/Setup Utility program to save
the new configuration information. See “Configuring the server” on page 31.
Some options have device drivers that you need to install. Refer to the
documentation that comes with the option for information about installing any
required device drivers.
If you have installed a new microprocessor, you might want to upgrade the
operating system to support symmetric multiprocessing (SMP).
Run the Configuration/Setup Utility program to save the new configuration
information. See “Configuring the server” on page 31.
64
Hardware Maintenance Manual: Netfinity 7100 – Type 8666