IBM 866631Y - Netfinity 7100 - 8666, Hardware Maintenance Manual

Page: 137 / 198

Error Code/Symptom FRU/Action
165-XXX-000 (Failed
Service Processor test)
1. Check error log for any I2C messages (see “I2C bus fault
messages” on page 141).
2. Remove ac power from system for 20 seconds, then rerun
service processor test. If problem persists, proceed to step 3.
3.
I/O Legacy Board. Before replacing the I/O Legacy Board,
ensure that I/O Legacy Board jumper J28 is not installed (the
default) when the error occurs.
180-XXX-
000
(Diagnostics LED
failure)
1. Run Diagnostic LED test for the failing LED.
180-XXX-001 (Failed
information LED panel
test)
1. Information LED Panel
2. Diagnostic LED Panel
3. I/O Legacy Board
180-XXX-002
(Failed
Diagnostics LED Panel
test)
1. Diagnostics LED Panel
2. I/O Legacy Board
180-XXX-003 (Failed
System Board LED test)
1. System Board
180-XXX-004 (Failed
Processor Board LED
test)
1. Processor/PCI Board
2. I/O Legacy Board
180-XXX-005 (Failed
SCSI Backplane LED
test)
1. SCSI Backplane
2. SCSI Backplane Cable
3. I/O Legacy Board
180-XXX-006 (Memory
Board LED test)
1. Memory Board
2.
Processor/PCI Board
3.
I/O Legacy Board
201-XXX-0NN (Failed
Memory test, see
″
Memory Settings
″
on
page 34.) NN = DIMM
location.
1. DIMM Location J1-J16
2. Memory card
201-XXX-999 (Multiple
DIMM failure, see error
text.)
1. See error text for failing DIMMs
2. Memory card
202-XXX-001 (Failed
System Cache test)
1. VRM 1
2.
Microprocessor CPU 1
202-XXX-002 (Failed
System Cache test)
1. VRM 2
2. Microprocessor CPU 2
202-XXX-003 (Failed
System Cache test)
1. VRM 3
2. Microprocessor CPU 3
202-XXX-004 (Failed
System Cache test)
1. VRM 4
2. Microprocessor CPU 4
Symptom-to-FRU index
127