IBM 620410U - IntelliStation E - Pro 6204, User Manual

Page: 86 / 166

10. If you are installing a 3.5-in. drive in bay 2, you must attach the 5.25-in
conversion kit, supplied with your option, to the 3.5-in. drive.
Note: You can install only a 3.5-in. device in bay 4.
11. If the drive is an IDE device, connect one end of the IDE signal cable into the
back of the drive and the other end of the cable into the IDE connector on the
system board. For the location of the IDE connectors, see “System board
internal cable connectors” on page 42. If the drive is a SCSI device, connect
one end of the SCSI signal cable into the back of the drive and the other end
of the cable into the 68-pin connector on the SCSI adapter.
Note: Route the signal cable so that it does not block the air flow to the rear
of the drives or over the microprocessor.
12. Connect the power cable to the back of the drive. The connectors are keyed
and can be inserted only one way.
13. If you have other options to install or remove, do so now.
14. Replace the support bracket.
15. Replace the side cover. See “Replacing the cover” on page 76 for details.
16. Reconnect the external cables and power cords; then turn on the attached
devices and the computer.
70
IBM IntelliStation E Pro Types 6204 and 6214: User’s Guide