IBM 620410U - IntelliStation E - Pro 6204, User Manual

Page: 84 / 166

Preinstallation steps: Before you install drives in your computer, verify that you
have all the cables and other equipment specified in the documentation that comes
with the drive. You might also need to perform certain preinstallation activities.
Some of the steps are required only during the initial installation of an option.
1. Read “Safety information” on page vii, “Handling static-sensitive devices” on
page 39, and the documentation that comes with your drive.
2. Choose the bay in which you want to install the drive.
3. Check the instructions that come with the drive to see if you need to set any
switches or jumpers on the drive. If you are installing a SCSI device, be sure to
set the SCSI ID for that device.
Installing a drive in bay 2 or 4: Do the following to install a drive in bay 2 or 4:
Attention: When handling static-sensitive devices, take precautions to avoid
damage from static electricity. For details on handling these devices, see “Handling
static-sensitive devices” on page 39.
1. Read the information in “Preinstallation steps” on page 68.
2. Turn off the computer and attached devices and disconnect the external cables
and power cords.
3. Remove the side cover. See “Removing the side cover” on page 60 for details.
4. Remove the support bracket. See “Removing the support bracket” on page 61.
5. Use a screwdriver to pry the filler panel and EMC shield away from the
computer.
Note: If you are installing a drive that contains a laser, observe the following
safety precaution.
68
IBM IntelliStation E Pro Types 6204 and 6214: User’s Guide