IBM 315, Hardware Maintenance Manual Supplement

Page: 49 / 151

Packet Driver Messages:
The following error
messages are for the packet driver. The explanation and
recommended action are included with each message.
PCNTPK-DOS-1 The command syntax is PCNTPK [-n]
[-d] [-w]
<
INT=packet_int_no
>
[IRQ=int_no] [IOADDR=io_addr]
[DMA=dma_no] [BUSTYPE=bus]
[DMAROTATE] [TP] [LED0=xx]
[BUSTYPE=bus] [LED0=xx]
[LED2=xx] [LED3=xx]
Explanation: The driver command was not entered
correctly.
Action: If you entered the command from the command
line, enter the command with the correct syntax. If the
command is in the AUTOEXEC.NET file, edit the file to
correct the syntax. The only parameters that should be
included are PCNTPK and BUSTYPE=PCI1.
PCNTPK-DOS-2 Unable to reset the PCnet device.
Explanation: The software could not reset the Ethernet
controller.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. If the problem persists, go to “General Checkout” on
page 2.
PCNTPK-DOS-3 Unable to initialize the PCnet device.
Explanation: The software could not initialize the
Ethernet controller.
Action: Do the following:
1. Verify that the Ethernet enable jumper is set to the
default (enable) position.
2. Check the interrupt settings in the configuration
programs. For more information, go to “Resolving
Hardware Configuration Conflicts” on page 77.
3. If the problem persists, go to “General Checkout” on
page 2.
PCNTPK-DOS-5 There is already a packet driver at
xxxx.
Explanation: The driver is already loaded at this memory
location. It cannot be loaded a second time at the same
location.
Action: Do not load the driver again. If you want to load
the driver at a different memory location, specify another
software interrupt address on the INT parameter.
PC Server 315 - Type 8638
45