IBM 26R0881, Installation And User Manual

Page: 60 / 78

Example: Configuration file
This topic contains an example configuration file.
// GENERATED FILE STARTS
// Blade Center 192.168.0.1
//IP ,Type (Center) ,Mode
192.168.0.1 ,bladecenter ,apply
//IP ,Type (Slot) ,Slot ,Mode ,Profile
192.168.0.1 ,slot ,1 ,enable ,"TempProfile BC-2Slot-1"
//IP ,Type ,Slot ,Port ,MAC_1 ,VLAN1 ,MAC_2 ,VLAN2
192.168.0.1 ,eth ,1 ,1 ,25:00:c9:00:00:70 ,0
192.168.0.1 ,eth ,1 ,2 ,25:00:c9:00:00:71 ,0
192.168.0.1 ,eth ,1 ,3 ,25:00:c9:00:00:72 ,0
192.168.0.1 ,eth ,1 ,4 ,25:00:c9:00:00:73 ,0
//IP ,Type ,Slot ,Port ,WWPN, ,Boot-order
localhost ,fc ,1 ,3 ,2f:fc:00:00:c9:00:00:00 ,none
//IP ,Type ,Slot ,Priority ,WWN ,LUN
localhost ,fctarget ,1 ,first ,00:00:00:00:00:00:00:00 ,0
Mapping of devices to ports
You can map devices to ports.
The mapping of ports to the devices on the blade is as follows:
v
Ports 1 and 2 are reserved for the on-board Ethernet devices.
v
Ports 3 and 4 are reserved for standard expansion cards.
v
Ports 5 to 8 are reserved for high-speed expansion cards.
The mapping between the OFM ports and the switch numbering on the chassis is
dependant on the chassis. For example, the BCS chassis routes both on-board
Ethernet devices to I/O Module bay 1.
The following table defines the mapping of the OFM ports to the switch
numbering on the chassis.
Table 12.
Chassis IO/M numbering
OFM port BC1 BCT BCH BCHT BCS
1 1 1 1 1
2 2 2 2 1
3 3 3 3 3
4 4 4 4 4
5 n/a n/a 7 7 2
6 n/a n/a 8 8 n/a
7 n/a n/a 9 9 2
8 n/a n/a 10 10 n/a
Multi-slot blades and the port offset parameter
Some blades fill more than a single slot in the chassis. As a result, they can access
more ports than a single-slot blade.
48
IBM BladeCenter Open Fabric Manager Installation and User's Guide