IBM 2210, Installation And Initial Configuration Manual

Page: 18 / 72

An additional source of information is the IBM 2210 Nways Multiprotocol Router
Description and Configuration Scenarios, GG24-4446.
Preparing for Installation
Note: Before installing the IBM 2210, be sure to read “Electronic Emission
Notices” on page 37.
Before beginning the installation procedure, make sure that the following tasks have
been completed:
¹
If the IBM 2210 is to be placed in a rack, provide a rack that meets the
requirements and that has space for the IBM 2210. See “Placing the IBM 2210
on the Table or in the Rack” on page 4 for information about rack
requirements. You will also need to provide the mounting hardware appropriate
for your rack.
¹
Verify that appropriate power outlets are available.
¹
Unpack the IBM 2210 and place it where it is to be installed.
¹
Provide any network interface cables not ordered with the IBM 2210.
¹
If the IBM 2210 was not pre-configured at the factory, you will need an ASCII
terminal to perform initial configuration. See “Attaching an ASCII Terminal to
the Service Port” on page 15 for information about ASCII terminals.
Verifying the Shipment Inventory
Check the components included with your shipment using the following list.
Hardware
¹
IBM 2210
¹
Network interface cables (optional)
¹
Service port cable
¹
Adhesive-backed feet (not available with all models)
¹
Cable management bracket (not available with all models)
¹
AC power cord
¹
Service kit with wrap plugs and service port converter (optional)
Optional Features
The following models of the 2210 support the following features:
2
2210 Install and Initial Config