![background image](http://html1.mh-extra.com/html/ibm/2210/2210_installation-and-initial-configuration-manual_3325183021.webp)
Placement in a Rack
If you choose rack-mounting, you must provide the rack; it is not provided with the
2210.
You can use any EIA standard 19-inch rack. The rack can be open or closed.
However, if you choose a closed rack, you must make sure that enough air flows
through the 2210. Covers on the front of the rack that would not let air reach the
2210 must be removed or modified to let air pass. Similarly, unvented rear rack
covers that would not let air exit the 2210 or would cause back pressure to build up
from several machines must not be used.
If you are placing the IBM 2210 in a rack:
1
To install the IBM 2210 with the cables at the back of the rack, go to step 2
on page 6.
To install the IBM 2210 with the cables at the front of the rack, follow these
steps for each rack-mounting bracket:
a
Remove the outer screws that attach the mounting bracket to the side
of the IBM 2210.
Figure 3. Removing the Screws on the Mounting Bracket
b
Turn the bracket around so that the ear is in front and is pointed away
from the machine.
Chapter 1. Installing the 2210
5
Summary of Contents for 2210
