IBM 2210, Installation And Initial Configuration Manual

Page: 52 / 72

‡@ —
Copyright IBM Corp. 1994, 1996
MOS Operator Control
Entering EasyStart operation. Type 'stop' or ¬C to terminate.
ELS messages are automatically displayed in this mode.
ISDN Install
EasyStart>
00:00:00
GW.001:
Copyright 1984 Massachusetts Institute of Technology,
Copyright 1989 The Regents of the University of California
00:00:00
GW.002: Portable CGW [not configured] Rel 16.0[R1] strtd
00:00:00 GW.005: Bffrs: 400 avail 400 idle fair 103 low 80
Top of xtp_init
00:00:00
EZ.001: Starting.
00:00:01 EZ.007: Waiting up to 6 seconds for devices to pass self-test.
00:00:04 EZ.009: *** Restarting Router ***
No Protocols Configured. Entering Quick Config
Router Quick Configuration for the following:
o
Interfaces
o Bridging
Spanning Tree Bridge (STB)
Source Routing Bridge (SRB)
Source Routing/Transparent Bridge (SR/TB)
Source Routing Transparent Bridge (SRT)
o Protocols
IP (including OSPF, RIP and SNMP)
o Booting
Event Logging will be enabled for all configured subsystems
with logging level 'Standard'
Note: Please be warned that any existing configuration for a particular item
will be removed if that item is configured through Quick Configuration
ˆ ˜
Notes:
1. If you are in EasyStart and you enter stop or press CNTL-C, the router restarts
and puts you into Quick Config automatically. For more information about
Quick Config, refer to the
Nways Multiprotocol Routing Services Software
User's Guide.
2. If you are in EasyStart and you enter pause, the router suspends the EasyStart
process. Enter restart to resume the process. Suspend EasyStart only for
debugging purposes.
36
2210 Install and Initial Config