IBM 10G Network Active Bypass, User Manual

Page: 48 / 56

Command-line parameters
The 10G Network Active Bypass unit uses a command-line interface to configure programmable
parameters and monitor the unit status.
Permissions required
Only the Admin account has permissions to configure and check the system parameters.
Command-line parameters
You can view and configure system settings with the command-line interface. Press the “Tab” key to
show the next available commands. If the string is partially completed, press the “Tab” key or the
“Space” key to finish the string. When there is only one option, press the “Tab” or “Space Key” to
complete the next string.
At the N2818 prompt, type a question mark (?) to access the following commands:
Command Action
! Comments
configure Enter configuration mode
exit Exit from the CLI
show Display system or configuration information
statistics Port statistics operations
system System action
Select the show command and then type a question mark (?) to display the following options:
Options Description
authentication Show authentication setting
bond Show bond
bypass Show bypass information
fan Show fan information
ha Show high availability
lfd Show Link Fault Detection information
links Show link status
management-if Show management interface information
notification Show notification setting
sfp Show sfp information
statistics Show port statistics
system Show system information
tap Show tap information
temperature Show current and highest temperature
time Show time setting
Select the configure command and then type a question mark (?) to display the following options:
30
10G Network Active Bypass V3.4: User Guide