IBM 10G Network Active Bypass, User Manual

Page: 47 / 56

Chapter 4. Using the command-line interface
You can use either the secure web-based management interface or the command-line interface to set and
to manage most of the configuration options for the 10G Network Active Bypass unit. This chapter
explains the command-line parameters that are available for you to use in order to manage the 10G
Network Active Bypass unit from the command-line interface.
Accessing the command-line interface
You can access the command-line interface for the 10G Network Active Bypass unit through a serial
terminal emulator or through an SSH remote shell emulator.
Connection requirements
The following table shows the requirements for the serial terminal emulator and the SSH remote shell
emulator:
Connection type
Port on 10G Network Active Bypass
unit
Cable
Serial terminal emulator Console port Console cable
SSH remote shell emulator Management port Management cable
Serial terminal settings
Use a serial terminal emulator and the following terminal settings:
Setting Value
Communications Port Typically COM1 (depending on the computer setup)
Emulation Auto detect
Bits per second 9600
Data bits 8
Parity None
Stop 1
Flow Control None
SSH port
The 10G Network Active Bypass unit SSH server uses the standard port 22.
User name and password
Use the administrator account with the default user name
admin
and the default password
admin
to
configure parameters and to monitor the status of the 10G Network Active Bypass unit.
Note: You can change this password through the command-line interface or through the management
interface.
© Copyright IBM Corp. 2011, 2014
29