IBM 10G Network Active Bypass, User Manual

Page: 38 / 56

SNMP settings
Use the SNMP Settings page to configure the SNMP destination IP and SNMPv2 community name, and
to enable or disable the SNMP trap function. The 10G Network Active Bypass unit provides an SNMP
trap function that can send messages to a trap server when the network segment status or power supply
status changes.
The following settings are used for configuring SNMP traps:
Table 12. SNMP settings
Field Description Default
Send SNMP traps Enable or disable the sending of
SNMP traps Disabled
SNMP traps destination IP Destination IP of the SNMP trap
server localhost
SNMPv2 community Community name of the SNMP trap
server public
Alias SNMP Alias of trap manager
Heartbeat status template Log entry template for heartbeat
status change messages bypassInOut bypassTrapModuleId u
${
segment
} bypassTrapStateBypass s
${ hb_state_name } bypassTrapOpMode
s "${
op_mode_name
}"
Power template Log entry template for power supply
status change messages bypassDiagnostics
bypassTrapDiagnostics s "Power
supply ${
power_supply
} is
${
power_state?ON:OFF
}"
Link template Log entry template for link status
change messages linkState linkTrapLinkName s
"${
segment }" linkTrapLinkState s
${
port_state
}
Link fault detection template Log entry template for messages
about link status change due to LFD. lfdReports lfdTrapLinkName s
${
lfd_port_name_active }
lfdTrapLinkState s
${
port_state?up:down }_force_$
{
lfd_port_name_passive
}_$
{
port_state?up:down
}
20
10G Network Active Bypass V3.4: User Guide