IBA ibaMS4xUCO, Manual

Page: 42 / 82

Manual ibaMS4xUCO
42 Issue 1.5
With the default settings, as shown in the figure above, the frequency will be
measured at each period and timeout is not active.

In mode 3 (pulse width/duty cycle) , the parameter
“timeout” is available. For a
parameter description refer to chapter 7.4.4.6.
The timeout is not active in the default setting (= 0 µs).

Show encoder inputs
True: the raw encoder digital inputs (A / B / N / MF) are displayed additionally in the
“Digital” tab.
False: the raw encoder digital inputs (A / B / N / MF) are hidden.
9.2.2.2 Hardware menu
– „Analog“ tab
In the „Analog“ tab, you can select all analog signals provided by the module.
Note
Number and type of the analog signals depend on the selected encoder mode, see
„General“ tab.
ibaPDA scales the calculated analog value to the target value with the appropriate SI
unit, see the following table.
Mode Type
3
ibaPDA
Signal names SI Description
1: A/B Pulse
counter DINT EdgeCounter - Number of the edges to be counted
2: Period /
Frequency DINT
DINT
REAL
PeriodTime
ABDirection
Frequency
ms
-
Hz
Period in milliseconds
„A before B“ or „B before A“
Frequency in Hz
3: Pulse
width / Duty
cycle DINT
DINT
REAL
PeriodTime
PulseWidth
DutyCycle
ms
ms
-
Period in milliseconds
Pulse width in milliseconds
Pulse duty factor [0..1]
4: Up/down
counter DINT UpDown-Coun-
ter - Number of edges to be counted (up/down)
3
Signal type