Among the channels that can be configured, there are also those of oil and fuel warning lights. In
both cases, the system prompts to make two measurements, for example, considering the fuel
level, in reserve and full tank. The software will then identify the threshold as the central value
between these two values. In the case of gasoline it is recommended to use as measurements two
conditions near to the reserve to set a precise value. As an example, choose as the first
measurement a condition in which a liter of fuel is still missing until the original warning light switch
off. Made this first step, add two liters to make the second measurement. In this way, the central
value will be exactly the correct reserve level. This method is even more important for bikes which
fuel level sensor is not a linear sensor.
17. Carburetion analysis
Through this menu the tracing of carburetion can be enabled. Firstly, choose which channel is
connected to the TPS and which to the Lambda probe. Please note: both channels must be
already configured, the TPS must be between 0 and 100 with the throttle closed and open, and the
Lambda probe must show the correct stoichiometric ratio or lambda value (by appropriately
configuring the minimum and maximum values of the respective channel).
It is then necessary to enable tracing. The analysis will be active all the time the equipment stays
on. At the shutdown data will be erased. The collected data can be analyzed directly from the
special screen on the Chrome "Table Display results" or can be exported and analyzed on a PC.
18. Alarms management
Using the “alarms management” menu it
is possible to set the behavior of each
LED included in Chrome. The brightness
of the LEDs can be chosen among three
different levels: low, medium and high.
Use the "brightness test" function to
check the chosen light intensity.
“RPM”
mode automatically sets the upper
LEDs, the system will split the range
set in the “RPM” menu in equal parts.
The upper LEDs will be turned on when
the RPMs rise, one by one, and will be
completely powered on when the RPMs reach the maximum. The threshold of each LED is still
