USB flash drive or to delete it, or save or delete all the files.
Downloaded files can be opened with Danas, moreover, in the same folder a specific file will be
stored to save all the settings. For further information, please refer to the Danas user manual.
13. Counters
Chrome features three different covered-distance
counters, two time-of-engine counters and a total
of performed laps counter.
Choose a counter and keep the DN button
pressed to erase that value.
14. Analog and digital inputs and gears
Through this menu it is possible to configure all
the Chrome inputs. Use "configure inputs" to
manually set each analog and digital input and
use "automatic configuration (analogs)" to set
the most common sensors for the analog inputs.
"Calculate gears ratio" allows to calculate the
gears. The latter are calculated by using the ratio
between "speed 1" (which should be placed on
the rear wheel) and the RPMs. Both inputs must
be correctly configured before proceeding with
the computation.
The system will calculate the gears with the data
that will be acquired during the day on the
selected circuit. ATTENTION: do not change the
circuit
between
the
acquisition
and the
calculation. Therefore, it is necessary to start the
data acquisition and record a session that
includes all the gears for at least 10s each (see
the appropriate section). It is possible to check if
the chosen settings are correct looking at the
“real time” menu.
Entering the page of the “Real Time” inputs, it is possible to switch to the next page by keeping the
DN button pressed. The second page is only a diagnostic page that allows to see the value of
voltage and temperature before and after elaboration. This page also includes the absolute values
of the oil and gasoline inputs. The latter input can be used to display the variation of the gasoline
signal level sensor when the content in the fuel tank varies.
