ATTENTION:
When the original dashboard is removed from the bike, some pull-up resistors can be removed too;
these resistors are usually needed to read sensors like oil or fuel levels. If a plug&play wire
harness is not used, check that the available signal is valid after the dashboard removal, otherwise
the use of proper pull-up resistors is needed.
Use of buttons to navigate through the menu
Chrome provides two buttons that can be externally replicated through the dedicated connector.
UP BUTTON
: allows to navigate in the menu selecting the upper entry. If the button is pressed in
the startup screen, the “view lap times” menu is directly shown.
DN BUTTON
: allows to navigate in the menu selecting the lower voices. If the button is pressed in
the startup screen, the main menu is directly shown.
ENTER A MENU
: keep DN button pressed to enter a menu or to modify a parameter.
EXIT FROM A MENU
: keep UP button pressed to exit from a menu or from a parameter
modification.
Press and hold down the UP button on the main screen to access the quick menu and to reset any
suspension potentiometers connected to analog channels (2 and 3).
Press and hold down the DN button on the main screen to make a direct download on USB key of
the current day data.
Modify numbers or text
As will be shown in the following, it is possible to give a name to a particular input or circuit, or to
set a numeric value for some parameters. The procedure will be explained in details in the
following paragraphs.
In all these cases it is possible to modify the name or the number by changing each character. UP
and DN buttons are used to change the character value. Keep DN button pressed to access the
adjacent character; keep UP button pressed to exit from the selection.
