3.2.6.
Starting at the tip, mount the chain drive links into the bar groove, leaving a loop at the back
of the bar. The chain will loosely fit until it placed on the sprocket (Figs. 6 & 7).
3.2.7.
Hold the chain in position on the bar and place the loop around the sprocket. Fit the bar
flush against the mounting surface so that the bar stud is in the long slot of the bar and the
adjusting pin is in the chain tension pin hole (Fig. 8).
3.2.8.
Fit the chain/sprocket end cover on by inserting the rear tab first into the rear tab slot, then
screw the chain tension adjustment knob without tightening it (Fig. 9).
Make certain of the direction of the chain
. If the chain is mounted
backwards, the saw will vibrate abnormally and will not cut.
Page 11
Ver 2
Summary of Contents for HYPS36LI
Page 1: ......
