Hyundai HSL1500T Track, Manual, Page: 50 / 80

4. V-Belt Tension
Check the V-belt tension midway between the crankshaft
pulley and alternator pulley (Fig. 4.8C). Deflection should
be between 1/4 to 3/8 in. (7-9 mm).
5. Adding Fuel
Use No. 2 diesel fuel only. Total tank capacity 28.7 gal
(109 L). Before adding fuel to the loader the key switch
must be off and the engine must be cool. Remove the fuel
cap (Fig. 4.8D). Use a clean approved safety container to
add fuel. Add fuel only in an area that is well ventilated
and away from open flames or sparks - NO SMOKING!
6. Fuel Filter Replacement
The fuel filter is located in the engine compartment on the
left hand side (Fig. 4.8E). The fuel filter should be
removed every 100 hours and any water or dirt found in
the element drained off. Change the filter every 300 hours.
To replace the filter; close the fuel inlet line shut - off
located on the side of the fuel tank (Fig. 4.8F). Remove the
filter element (Fig. 4.8E). Lubricate the seal on the new
filter and install the filter hand tight. Open the fuel inlet
shut - off. It may be necessary to remove air from the fuel
system after changing the filter element. (Refer to Section
4.8-7).
4. MAINTENANCE
Fuel Filter
Fig 4.8E
Alternator
Pulley
Fan Pulley
Crankshaft Pulley
Fig. 4.8C C-834
Fuel Tank
C3948
Fig.4.8D
C3786
WARNING
To avoid personal injury
never add fuel to the
loader when the engine is
running or is hot. NO
SMOKING.
51
Hand Primer