![background image](http://html1.mh-extra.com/html/hyundai/hsl1500t-track/hsl1500t-track_manual_2197029004.webp)
5
1. SAFETY PRECAUTIONS
The following precautions are suggested to help prevent accidents.
A careful operator is the best operator. Most accidents can be avoided by observing certain precautions. Read and take the
following precautions before operating this loader to help prevent accidents. Equipment should be operated only by those
who are responsible and instructed to do so.
1.
Read this manual carefully before using the loader.
Working with unfamiliar equipment can lead to accidents.
2.
Do not allow anyone to ride on the loader with the
operator.
3.
Make sure the seat bar is installed and functioning at all
times.
4.
Never run the engine in a closed building without
adequate ventilation, as the exhaust fumes can cause
death.
5.
Always fasten the seat belt around you before starting the
engine. Never fasten the seat belt behind you.
6.
Never attempt to start the engine while standing beside
the unit unless as specified in this manual or under
specific service and backhoe operation procedures. Start
the engine only while sitting in the operator’s seat with
the seat belt fastened around you. Always check to make
certain that the seat is secured to the frame.
7
Keep the operator’s area free of debris.
8.
Never enter or leave the loader while the engine is
running. Always lower the lift arms down against the
frame, drop the attachment down to contact the ground,
set the parking brake and shut off the engine prior to
leaving the loader.
9.
If the unit is equipped with a cab enclosure kit always
close the door prior to operating the loader lift arms.
10. Do not operate the loader unless all safety equipment,
shields, seat belt, seat bar, hydraulic controls, parking
brake, operator guard, and lift arm supports are working
properly, as well as all safety and instruction decals are in
place.
OPERATING THE LOADER
1.
Always drive the loader at speeds compatible with safety,
especially when operating over rough ground, unfamiliar
terrain, when crossing ditches or when turning.
2.
Avoid jerky turns, starts, stops, or reverses.
3.
Use care when operating on steep grades to maintain
proper stability.
4.
Do not turn the loader while the lift arms are in the
raised position.
5.
Be careful when driving through door openings or under
overhead objects. Always make sure there is sufficient
clearance for the operator’s guard.
6.
When travelling on public roads, know the local rules and
regulations and make sure your loader is equipped with
the proper safety equipment.
7.
Always be sure of water, gas, sewage and electrical line
locations before you start to dig.
8.
Watch out for overhead and underground high-voltage
electrical lines when operating the loader.
9.
Always park the loader on level ground where possible. If
the loader is to be parked on an incline, always lower the
attachment so it contacts the ground, set the parking brake
and block the wheels/tracks.
10. Do not leave the loader when it is in motion.
11. Do not dismount from the loader and leave the loader lift
arms raised, unless following specific service procedures.
Always lower the lift arms down against the frame and
drop the attachment down to contact the ground.
12. Always be watchful of bystanders when operating the
loader.
13. Always carry the attachment low for maximum stability
and visibility.
14. Exercise extreme caution when operating the loader with
a raised attachment.
15. Never attempt to lift loads in excess of loader capacity.
16. Check that the foot pedals are locked before getting out of
the operator’s seat.
17. Keep both hands on the control levers while the loader is
in motion.
MAINTENANCE
1.
Stop the engine before performing any service on the
loader.
2.
Never refuel the loader while smoking or with the engine
hot or running.
3.
Replace all missing, illegible or damaged safety and
warning decals. See Section 5.3 for list.
4.
Do not modify or alter, or permit anyone to modify or
alter this loader or any of its components or any loader
function.
5.
Do not bypass the safety system. Consult your
authorized equipment dealer if your safety controls are
malfunctioning.
6.
Do not make mechanical adjustments while the loader is
in motion or when the engine is running. However, if
minor engine adjustments must be made, securely block
the loader with the wheels clear of the ground, and use
extreme caution.
7.
Do not attempt to repair or tighten hydraulic hoses when
the system is under pressure, when the engine is running
or when the lift arms are raised.
8.
Do not get under the attachment or lift arms or reach
through the lift arms when they are raised.
9.
Never attach the chains or ropes to the operator’s guard
for pulling purposes, as the loader can tip over.
10. Whenever servicing or replacing pins in cylinder ends,
buckets, etc., always use a brass drift and a hammer.
Failure to do so could result in injury from flying metal
fragments.
11. Cooling system operates under pressure which is
controlled by the radiator cap. It is dangerous to remove
the cap while system is hot. Always turn cap slowly to the
first stop and allow the pressure to escape before
removing the cap entirely.
12. Keep the operator and foot pedal areas free from debris.
13. For lifting and towing instructions, refer to Sections 3.8
and 3.9 of this manual.
Summary of Contents for HSL1500T Track
Page 21: ...22...