39
4. 2
SERVICE ACCESS
1.
Lift Arm Support
For safety while performing regular service or
maintenance work, the loader is equipped with lift arm
support pins. The lift arm support pins, when extended,
prevent the lift arms from dropping if hydraulic pressure is
relieved or the hydraulic controls are accidentally cycled.
To operate the lift arm support, first remove any bucket or
attachment from the quick-tach and raise the lift arms to
full height. Push the lift arm support handle (Fig. 4.2A) out
toward lift arms to extend the lift arm supports (Fig. 4.2B).
Slowly lower the lift arms down on to the pins. To retract
the lift arm supports, lift the lift arms off of the pins before
retracting pins.
2.
Seat Removal
The seat assembly can be removed to provide access to the
controls, hydraulic and hydrostatic components. To
remove the seat assembly, remove the fasteners located at
the front of the seat. DISCONNECT ELECTRICAL
PLUG! Lift the seat assembly out of the machine. When
installing the seat, be sure the seat plate is locked in place
at the rear (Fig. 4.2C).
3.
Battery Access
The batteries are located in a compartment found behind
the operators seat (Fig. 4.2D). Remove the seat and
remove the bolt holding the battery cover in place. The
battery compartment is hinged with a prop rod to hold
open.
See Section 4.11 for Boosting Procedures.
Fully retract lift support
pins before raising or
lowering lift arms.
IMPORTANT
To avoid personal injury:
Do not leave lift arms up
unless the lift arm
supports are engaged.
WARNING
4. MAINTENANCE
Fig. 4.2C
Fig. 4.2B
C4441
C694
Electrical Plug
C3135
Fig. 4.2A
Fig. 4.2D
C813
Prop rod
Bolt
Lift Arm Support
C3949
Summary of Contents for HSL1500T Track
Page 21: ...22...