50
4. 8 ENGINE MAINTENANCE
1.
Engine Specifications
Make ...................................................................... Kubota
Model ....................................................................V3300T
No. of Cyls ...................................................................... 4
Horsepower (Gross) ................................................... 87.4
Power (ISO 9249 Net Power) ..............................61.9 kW
Power CE (ISO 9249 Net Power) ........................61.5 kW
Max. High Idle................................................. 2750 RPM
Max. High Idle CE ...........................................2500 RPM
Max. Torque .....................206 ft. lbs. (280 N·m) @ 1400
Displacement ............................... 202.53 in.³ (3318 cm³)
Engine Oil ................................................ 14 qts. (13.2 L)
Firing Order .................................................... 1 - 3 - 4 - 2
Alternator....................................................................60 A
Oil Check.................................................................. Daily
Oil Change ........................................................... 150 hrs.
Filter Change ........................................................ 300 hrs.
2.
Oil Level Check
Check the oil before engine start up. If the engine has been
running let it cool for at least 5 minutes.
To check the oil level, stop the engine with the loader on
level ground, open the rear door and remove the dipstick
(Fig. 4.8A).
Keep the oil level between the full and low mark on the
dipstick. Do no fill above the full mark.
3.
Engine Oil and Filter Replacement
Operate the engine until warm, approximately 5 minutes.
Stop the engine. Remove the oil drain plug located at the
bottom of the oil pan. Remove the oil filter (Fig. 4.8B).
Clean the filter housing surface. Put clean oil on the seal of
the new filter and install the filter hand tight.
Replace the oil drain plug. Remove the filler cap and add
5W40 API classification CF engine oil. Start the engine
and run for 5 minutes. Stop the engine and check for leaks
at the filter. Recheck the oil level and add oil until the level
is at the top mark on the dipstick.
WARNING
To avoid personal injury:
Stop, Cool and Clean the
engine of flammable
materials before
servicing. Never service
or adjust machine with
engine running.
4. MAINTENANCE
C3783
Fig. 4.8A
Dipstick
Location
C3786
Fig. 4.8B
Engine Oil
Filter
IMPORTANT
It Is recommended that
you abide by all
applicable environmental
regulations when
disposing of oil.
Summary of Contents for HSL1500T Track
Page 21: ...22...