Hyundai HSL1500T Track, Manual, Page: 16 / 80

2.9 ELECTRICAL SOLENOID
AUXILIARY
CONTROLS
Auxiliary Hydraulic (solenoid operated – standard).
A switch located in the L.H. steering control lever (Fig.
2.9A) is used to engage the loader’s auxiliary hydraulic
circuit to power attachments such as post hole augers,
sweepers etc. Pressing and holding the switch in position
1 (Fig. 2.9A) provides hydraulic flow to the female quick
connect coupling located at the front of the lift arms (Fig.
2.9C). Releasing the switch returns the auxiliary hydraulic
circuit to neutral, stopping hydraulic flow.
Pressing and holding the switch in position 2 (Fig. 2.9A)
provides hydraulic flow to the male quick connect
coupling located at the front of the lift arms (Fig. 2.9C)
Releasing the switch returns the auxiliary hydraulic circuit
to neutral, stopping hydraulic flow.
For continuous flow to the auxiliary hydraulic circuit, a
toggle switch is located on the L.H. instrument panel (Fig.
2.9B). Placing the switch in the “ON” position provides
continuous hydraulic flow to the female quick connect
coupling located at the front of the lift arms (Fig. 2.9C). To
stop hydraulic flow to the auxiliary hydraulic circuit,
return the switch to the “OFF” position (Fig. 2.9B). When
the switch on the instrument panel is in the “ON” position,
the switch located in the L.H. control lever is not operable.
NOTE: See Section 2.2 for information on the control
handles.
2. CONTROLS
C3793
Fig. 2.9B
Fig. 2.9A C3015
AUXILIARY HYDRAULIC CONTROL
SEAT SIDE
ROPS SIDE
2
1
NEUTRAL
To avoid personal injury,
lower the lift arms, shut off
the engine, raise the seat
bar and cycle the lift arm
and bucket controls to
ensure they are locked.
Then, unlatch the seat belt
and exit the loader. Do not
enter or exit with the
engine running unless as
specified in this manual or
under specific service and
backhoe operating
procedures.
WARNING
17
C4112
Fig. 2.9C
Female Quick
Coupling
Male Quick
Coupling
Toggle Switch