![background image](http://html.mh-extra.com/html/hyundai/160d-9l/160d-9l_manual_2196422174.webp)
7-21
Oil
Close
Install the filter to the filter head.
Tighten the filter until the gasket contacts the
filter head surface.
Tighten 3/4 to 1 turn the gasket makes contact
with filter head.
Mechanical over-tightening may distort the
Mechanical over-tightening may distort the
threads or damage the filter element seal.
threads or damage the filter element seal.
Oil
Operate the engine at low idle and inspect for
leaks at the filters and the drain plug.
Shut the engine off and check the oil level with
the dipstick. Add oil as necessary to bring the
oil level to the H (high) mark on the dipstick.
Allow 15 minutes for oil to drain down before
Allow 15 minutes for oil to drain down before
checking.
checking.
Clean and check the lubricating oil drain plug
threads and sealing surface.
Install the lubricating oil pan drain plug.
·
Tightening torque
M18 : 6.1 kgf
·
m (44 lbf
·
ft)
M22 : 8.2 kgf
·
m (59 lbf
·
ft)
Fill the engine with clean oil to the proper level.
·
Quantity : 14.2
ℓ
(3.7 U.S.gallons)
2609A6MA07
160D7A6MA08
2609A6MA09
160D7A6MA10
(5)
※
(6)
(7)
(8)
※
Apply a light film of lubricating oil to the gasket
sealing surface before installing the filter.
Fill the filter with clean lubricating oil.
Fill the filter with clean lubricating oil.
The lack of lubrication during the delay until
The lack of lubrication during the delay until
the filter is pumped full of the start-up can
the filter is pumped full of the start-up can
damage the engine.
damage the engine.
(4)
※