7-43
CHECK TRANSMISSION OIL LEVEL
CHECK TRANSMISSION OIL LEVEL
The oil level check must be carried out as follows;
Oil level check (weekly).
At horizontally standing truck.
Transmission in neutral position.
In cold start phase, the engine must be running
about 2~3 minutes at idling speed, and the
marking on the oil dipstick must then be lying
above the cold start mark COLD.
Check oil level at operating temperature of the
transmission (about 80~90 ˚C ) and the engine
idling speed.
Loosen oil dipstick by counterclock wise
rotation, remove and clean it.
Insert oil dipstick slowly into the oil level tube
until contact is obtained, and pull it out again.
On the oil dipstick the oil level must be lying in
the zone HOT.
Insert the oil dipstick again, and tighten it by
clockwise rotation.
When checking, put the parking brake switch
When checking, put the parking brake switch
in the LOCK position and fix the tires with
in the LOCK position and fix the tires with
blocks.
blocks.
HOT
COLD
ZONE " HOT"
Dipstick
REPLACEMENT OF TRANSMISSION OIL
REPLACEMENT OF TRANSMISSION OIL
AND FILTER ELEMENT
AND FILTER ELEMENT
Operate the truck for a few minutes in order to
warm the transmission oil.
Move the truck to flat ground. Lower the forks
to the ground and slightly apply downward
force.
Put the parking brake switch in the LOCK
position and stop the engine.
Open transmission air breather to relieve internal
air pressure.
Remove the transmission drain plug. Allow the
transmission oil to drain into a suitable container.
30)
30)
(1)
(2)
(3)
(4)
(5)
31)
31)
(1)
(2)
(3)
(4)
(5)
Drain plug
Air breather
160D9LMI41
110D9MI42
①
②
③
④
