POWER DISTRIBUTION MODULE (PDM)
COMPONENTS
Remove and Install
Turn key to ON position. Check all indicator lights
for correct operations as described in the Operat-
ing Manual. Check operation of the horn. Start
the engine by turning the key switch to the START
position. If any indicator lights DO NOT operate
correctly, check the fuses. The fuses are located in
the Power Distribution Module (PDM) (see Fig-
ure 30) which is under the hood next to the battery
on the right side. See Figure 29.
Figure 30. PDM Component Parts
Legend for Figure 30
1. FRONT WORKLIGHT (20 AMP)
2. START RELAY
3. BATTERY (25 AMP)
4. STARTER (30 AMP)
5. FUEL/RUN RELAY
6. FUEL/RUN (30 AMP)
7. FRONT WORKLIGHT RELAY
8. BACKUP RELAY
9. BACKUP (20 AMP)
10. BATTERY (20 AMP)
11. TRANZORB
12. IGNITION 3 RELAY
13. IGNITION 3+ (20 AMP)
14. IGNITION 1 RELAY
15. IGNITION 1+ (20 AMP)
16. REAR WORKLIGHT RELAY
17. REAR WORKLIGHT (20 AMP)
18. (20 AMP)
19. RESISTOR (68 OHM)
Battery
REMOVE
1.
Raise the hood. Disconnect the battery.
2.
Remove battery lockdown bar from battery. Re-
move battery from lift truck. See Figure 29.
INSTALL
1.
Install new battery onto battery tray. Install
battery lockdown bar onto battery. See Fig-
ure 29.
2.
Connect the battery. Close the hood.
Power Distribution Module (PDM) and Component Parts
2200 SRM 1771
28
