© 2022 HyQuest Solutions
99
Operation
4.3.7.6
Sensor Settings Screen 4/4 - Logging (Level 6)
The Sensor Validation screen shows the defined Reject high and Reject Low settings for the given sensor.
Up
Move up through sensor setting screens.
Down
Move down through sensor setting screens.
Right
Not Used.
Left
Move to Sensor Menu.
Enter
Not used.
4.3.7.7
Sensor Calibration Screen (Level 6)
The Sensor Calibration screen is provided as a convenient tool for adjusting the sensor scaling offset on site, without a
tool such as a laptop being required. The calibration process is done by entering the actual sensor value as measured by
an external reference source such as a gauge board, EPB or thermometer.
§
'Scaled' is the current, adjusted sensor value reading. This is the value
Where:
§
is the multiplier used to convert to engineering units.
§
is the offset used to convert to engineering units.
§
is the offset calculated during this calibration.
All of these parameters can be edited in iLink. Additionally the Sensor Calibration Screen alows to modify the user offset.
§
'Offset' shows the user offset. When entering the screen it will show the current user offset. After entering a calibration
value it will show the updated user offset.
§
'Final' allows the user to set the target value and hence the user offset by performing the following steps:
§
Press enter in order to edit the value
§
Choose a digit with the left- and right key
§
Set the digit with the up- and down key
§
Confirm the target value by pressing the enter key. This will update the 'Offset' value
§
In order to store the 'Offset' press the left key which will lead to the 'Sensor Callibration Acceptance Screen' (see this
section for details).
Up
Increment digit by one.*
Down
Decrement digit by one.*
Right
Move right to next digit.*
Left
Move left to next digit.*
Enter
Press to enter or exit edit mode.
4.3.7.8
Sensor Calibration Acceptance Screen (Level 6)
The Sensor Calibration Acceptance screen is used to accept or decline the sensor calibration. If No is selected, the
calibration offset is discarded. If Yes is accepted, the interim offset entered in the calibration screen previously is stored in
the sensor’s offset location and overwrites the previous value.
Up
Move select up the menu items
Down
Move select up the menu items
Right
Not used
Left
Not used
Enter
Accept select option
