Hypertherm Koolant Koolers N-Series, User Manual, Page: 18 / 77

Installation ‐ Unpacking from the Crate
16
6.3 Unpacking from the Crate
The chiller is secured to the skid at the bottom of the crate with metal shipping brackets. The crate is held
together with wood screws. To remove the chiller from its crate:
1. Move the crated chiller as close as practical to its installation location.
2. Start disassembly of the crate by removing the T25 Torx® head wood screws securing the top panel of
the crate.
3. Continue disassembly by removing the T25 Torx® head wood screws holding the two short panels of the
crate. This will allow access to the internal bracing.
4. Remove the T25 Torx® head wood screws securing the internal bracing to the two long sides.
5. Remove the 3/8 ‐ 16 bolts securing the shipping brackets to the base of the chiller using a 9/16” wrench.
6. Cut the shipping bag that the chiller was placed in.
7. Cut or unwrap the plastic shrink ‐ wrap from the unit.
8. Remove the desiccant bag located in the ebox, along with the desiccant bag located inside the chiller,
referencing section 6.4 on how to gain internal access to the chiller.
9. Remove the lag bolts securing the shipping brackets to the skid using a 1/2” wrench.
10. Remove the shipping brackets.
11. Use a forklift to lift the chiller until its casters clear the top boards of the skid.
12. Pull the skid from under the chiller.
13. Lower the chiller onto the floor.
14. Move the chiller into its final installation position.
15. Lock the casters.
Figure 5: Crated Chiller
Hypertherm, Inc. Part Number: 810540