HL-20210202
Hydraloop Installation Manual
15
After this, three options are accessible:
1.
System restart
: Pushing this button restarts the
Hydraloop system.
2.
Empty tanks
: Pushing this button opens the purge
valves of the Hydraloop system. This might be
necessary for servicing.
It is also possible to empty the water tanks without WiFi
connection/App:
-
unplug the power plug from the wall socket,
-
wait until the audible alarm (2 beeps) sound,
-
immediately plug in again, if inserted back in time
1 confirmation* beep will sound,
-
immediately unplug the power plug again,
-
after 2 beeps immediately plug it in again.
*
If the 1 confirmation beep did not sound, you have to insert
quicker after the 2 beeps. To repeat the procedure: wait 1
minute and repeat procedure.
3.
Test routine: This option starts the Hydraloop test
routine. The test routine performs all actions the
Hydraloop normally performs for treatment in about 15
minutes. This test should always be performed at
installation and after replacement of parts. It is
necessary to do a test routine to check for possible
damage caused by transportation of the unit:
a.
Open the Hydraloop front plate by lifting it from
the floor up and then you can move it upwards and
set it aside, so all tanks and internal parts are
visible,
b.
Press ‘test routine’ and open one of the showers in
the house and wait until shower greywater enters
the Hydraloop unit. Let it run for about 12 minutes
and then close the shower. The test routine takes
about 15 minutes in total. After this test routine the
system is ready for usage. If an issue occurs the
App will inform you about the issue. If you have
questions, please contact us.
Note: Check the Hydraloop unit for water leaks during the test routine.
If you need assistance call your Hydraloop dealer or contact Hydraloop technical support via email
or phone on number:
+31 88 100 3500 (EU) | +1 414 89 500 21 (USA)